Lifestyle 81002 Anleitung Und Warnhinweise

EN
Inflatable Bath Tub
Instructions & Warnings
WARNING
This item is not for use outside of the tub. This item is not a life-saving device. This is not a
flotation device. To prevent drowning, never leave child unattended in tub!
SPECIFICATIONS
Parts included:
One Inflatable Bath Tub
Classic Style
Manufacture Item No. 81002
Bubbles Style
Manufacture Item No. 81001
Recommended Age: 6 to 24 months
Recommended maximum number of persons: 1 child per inflatable bath tub
Patents and trademarks pending worldwide.
INSTRUCTIONS
INFLATION
For best results, inflate by mouth or low-pressure pump. Do not use a high-pressure hose
or compressor. Do not over-inflate. The Inflatable Bath Tub features two valves: one on the
underside of unit, and one on the outside wall (Rapid Inflation Valve).
Rapid Inflation Valve
This unique valve allows a larger amount of air to enter and escape for
quick inflation and deflation. *If you are experiencing a leak, it may be
caused by dust or lint around the valve area. Simply blow into the valve
or wipe around the valve base where it touches the pink diaphragm to
help solve the problem.
Each valve will inflate a separate compartment of the Inflatable Bath Tub. Do not use the
Inflatable Bath Tub unless both compartments have been inflated according to the following
instruction:
1. Locate the valve on the underside of the unit.
2. Begin by inflating the floor compartment of the Inflatable Bath Tub by mouth only. Do not
use a pump of any kind on the floor compartment to avoid damaging the product.
squeeze
3. Blow into the valve, while squeezing the base of the valve
slightly. This opens the flap inside the valve, allowing air to
enter easily.
4. Do not try to remove every last wrinkle from the Inflatable Bath Tub, as this will cause
over-inflation.
5. Once inflated, close the valve cover, and press the valve into the stem, so that the valve is flat
with the surface of the Inflatable Bath Tub. The floor compartment should now be inflated.
6. Next, locate the Rapid Inflation Valve on the outside wall
of the Inflatable Bath Tub.
7. Lift the black valve cover and blow directly into the valve,
until the walls of the Inflatable Bath Tub are fully inflated.
PLEASE NOTE: There are two recesses at the head of the Inflatable Bath Tub: one circular
recess, which can hold a small cup or toy, and a rectangular recess, which can hold soap or
washcloth.
TO FILL
1. Position the fully inflated Inflatable Bath Tub, so that the foot of the Inflatable Bath Tub is
directly under the bathtub faucet.
2. To secure the Inflatable Bath Tub in place, find the suction cup underneath the head of
the Inflatable Bath Tub and moisten it. Press down on the suction cup to form a seal on the
bottom of the tub, thereby holding the Inflatable Bath Tub in place.
3. Find the drain valve in the bottom of the Inflatable Bath Tub and inspect to be sure it is
firmly closed.
4. Turn on the faucet and fill the Inflatable Bath Tub with lukewarm water, to the maximum
level as indicated on the inside wall.
CAUTION: Always feel the water temperature by hand before placing the child in the water. Never
place a child in water that is too hot. Water should be warm and pleasant to the touch.