Werbung
All products of the MODUSV range (uninterruptible power supplies with integrated battery) are electric
devices requiring specific installation. They may only be installed by specialized and authorized personnel.
Private persons buying a product of the MODUSV range must turn to a professional electrician to install the
product. Before the installation, the electrician must read this manual completely.
The manual is available on the internet site www.comatec.it. The electrician must know the instruction's
index below as well as the symbols indicated at the end of this page. In case of doubt he must immediately
interrupt the installation and contact our technicians under the following e-mail address:
informations@comatec.it
INDEX OF THE INSTRUCTIONS AND INFORMATION ABOUT THE INSTALLATION
Important information.
Waste management and recycling of the product.
Precautions, maintenance and notes for users.
Installation project.
Contents of the packing.
Unpacking instructions.
Measurements and weight of the product.
Label data.
Removal of the battery and the card before beginning the installation.
Fastening of the main module MODUSV to the battery element MDBCASE.
DIN rail mounting of the product .
Wall fixing of the product.
Pre-connections of the output circuit (secondary).
Pre-connections of the input circuit ( primary ).
Fastening of the electronic card.
Battery connection for models with 12 V output voltage.
Battery connection for models with 24 V output voltage.
Connection of an extra battery for models with 12 V output voltage.
Connection of an extra battery for models with 24 V output voltage.
Fastening of the battery and location of the battery connection cables.
Connection of the input and output terminals to the electronic card.
Closing of the top of the product MODUSV and the battery element MDBCASE.
Signalling – Signals for the remote control of all parameters ( Remote Control ).
Product appraisal.
Warranty.
This symbol draws the electrician's attention to important information on the installation and the
functioning of the product.
This symbol draws the electrician's attention to the fact that the non-isolated tension inside the
product may cause electric shock. Never work on the live product.
This symbol draws the electrician's attention to the precautions to be taken during the installation
of the product.
This symbol draws the electrician's attention to forbidden work steps during the installation of the
product.
This symbol draws the electrician's attention to the prohibition of unauthorized changes on the
product.
Manuale MPF0280
Page 2
Page 3
Page 3
Page 4
Table A
Page 17
Table B
Page 19
Table C
Page 20
Table D
Page 21
Table E
Page 23
Table F
Page 25
Table G
Page 27
Table H
Page 29
Table I
Page 31
Table K
Page 33
Table L
Page 35
Table M
Page 36
Table N
Page 38
Table O
Page 40
Table P
Page 42
Table Q
Page 45
Table R
Page 46
Table S
Page 47
Table T
Page 48
Page 50
Page 4
Page
2
to 52
Werbung
