Analog Target Value - Output Pressure - Asco SentronicLP 617 Serie Installationshandbuch

EN
3.

ANALOG TARGET VALUE - OUTPUT PRESSURE

Setpoint offset
The pressure zero point of the setpoint can be changed using the DaS software. To do this, in the section "Setpoint
settings" switch to "Customer". The maximum adjustment range for the zero point is from -50% to +100%.
Maximum
output pressure
SHUT-OFF
-50% PMR
WARNING: Output pressures greater than the PMR (Pressure Maximum Range) will not be regulated by the valve,
i.e. the maximum output pressure is limited to the PMR.
In order to prevent damage to the sensor, the supply pressure should always be less than the maximum
input pressure (MAP) (see table).
Setpoint span
The pressure range of the target value can be changed using the DaS software. To do this, in the section "Setpoint
setting" switch to "Customer". The adjustment range for the pressure is 10% to 200%.
Maximum output
Maximum output
50 mV
0.1 mA
4.08 mA
The maximum setting for the pressure range is 200% of the PMR (Pressure Maximum Range).
IM50279003-18
Downloaded from www.Manualslib.com
PMR
Offset adjustment
pressure
(PMR)
(1) 100%
pressure
0.5 PMR
(1) 70%
SHUT-OFF
0
0
0
4
Spam Adjustment
manuals search engine
Maximum output
Set point version
(2)
(3)
(15)
10 V
20 mA
20 mA
INSTALLATION
Maximum input
pressure pressure
PMR MAP
(bar) (bar)
3 bar 5 bar
6 bar 8 bar
10 bar 12 bar