Inserting The Batteries - TomTom Remote LINK Logbook Bedienungsanleitung

Borna_Logbook.book Page 3 Thursday, January 21, 2010 9:53 AM

Inserting the batteries

1. Hold the sides of the Remote LINK and press the latch on
2. Insert the batteries (2 x AAA/LR3) in the Remote LINK.
3. Replace the battery cover.
Establishing a paired connection
The following instructions only apply if your Remote LINK has
not been connected to a TomTom LINK 300/310. Press any key
to turn on your Remote LINK and see "Understanding your
Remote LINK" to check the status of the device.
If the device is not paired with a LINK 300/310, then do the
following.
1. Make sure the LINK 300/310 is properly installed in the
2. Turn on the ignition.
3. Make sure there are no other vehicles installed with a LINK
4. Press any key on your Remote LINK to switch it on.
5. Press any two buttons at the same time until you hear a
Downloaded from www.Manualslib.com
Preparing your Remote LINK
the back of the device to open the battery compartment.
Make sure you insert the batteries in the correct way, as
shown inside the battery compartment.
vehicle.
300/310 located within a distance of 30 metres.
If the LEDs on all three buttons are flashing, then the device
is not paired and you need to continue with the next step.
sound.
manuals search engine
3
EN
Pre-
par-
ing
your
Re-
mote
LINK