Mounting - ABB RLM01 Inbetriebnahmeanweisungen

Commissioning

3.3 Mounting

The module should preferably be attached vertically on a DIN mounting rail. To do
this, place the two rear-side clamps on the top edge of the mounting rail. Then press
lightly on the underside of the module until the clamps spread apart and the bottom
edge of the rail locks audibly into place. The mounting location should be selected
so that the RLM 01 can discharge heat arising from power loss without hindrance. A
distance of > 30 mm should be maintained between the top/bottom of the module
and cable ducts, other devices, etc.
Fig.: Attachment to a DIN mounting rail
3BDD011600R05 11