Preparing For Use - Philips DL8781 Bedienungsanleitung

Preparing for use

Inserting/removing the batteries
body so as to measure the bioelectrical impedance and estimate body fat.
The electrical current is small and may not be felt. This BIA technology
is non-invasive and toxic-free. The electrical current mentioned above is
less than 1mA.
Insert new batteries (4x 1.5V AAA) before the first use.
Replace weak batteries before they discharge completely.
Note: Data will be lost when the battery is completely empty.
If you do not intend to use the device for a long period of time, it is advised
to remove the batteries before storing.
Caution: Replace all four batteries at the same time. Do not mix the old
batteries with the new ones.
This device has a battery low indication. When the battery level is below
operating value, this will be indicated by the low battery icon after which the
device shall switch off within 4 sec.
1 Open the battery compartment at the back of the device.
2 Insert the batteries (4x 1.5V AAA) into the battery compartment according
to the polarity indications marked inside the compartment.
-
The digits "8888" will show on the display.
English
9