MPI Tech LinkCom IV Kurzanleitung Seite 13

NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio Communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Only use this product with a Class 2 Direct Plug-In Transformer rated 5 VDC
minimum 0.5 A.
Changes or modifications not expressly approved by MPI Tech could void
the user's authority to operate this equipment according to part 15 of the
FCC rules.
CE conformance
This product has been developed and produced in accordance with the EMC
directive and the Low Voltage directive and therefore carries the CE mark.
Trademarks
Company and product names mentioned in this guide are trademarks or
registered trademarks of their respective owners.
MPI Tech A/S
Vadstrupvej 35
DK-2880 Bagsvaerd
Denmark
Phone: +45 4436 6000 - Fax: +45 4436 6111
www.mpitech.com