SE Audiotechnik SMX 12A Handbuch Seite 38

To mount the monitor on a SPS20 pole bar, use the PS �5 adapter as follows:
7. Screw the PS �5 adapter tightly the into the SMX �2UB M10 thread.
8. Loosen the star screw of the PS �5 pole adapter, so the pole entrance is not obstructed.
�. Push the U-bracket until the handle screw is in position B of the U-bracket's arm, as shown in fi gure 8.
Tighten softly the handle screws.
10. Fix tightly the SPS20 pole bar into the M20 thread of the subwoofer.
11. Lift the SMX 12A with the left and right handles of the box and insert the U-bracket into the pole bar.
See fi gure 10.
12. Adjust the vertical angle of the box and fi x the handle screws tightly.
13. Plug in the signal and power cables, and set the level and preset according to your application.
15
Figure �. Attaching the SMX �2UB U-bracket to the SMX 12A monitor.
Notice the three available mounting positions depending on the application.
2
�
Figure �. PS �5 pole adapter attached to the SMX �2UB U-bracket.
2 A B C
�
�