Connecting The Power Source - Rentokil Lumnia Standard Handbuch

4. Connecting the Power Source

Once installed as above and mounted correctly, connect the plug connector for the
cable into the power socket.
When operational, the front icon will illuminate blue.
If the product is in Service Mode or the front louvre is open the icon on the front will
illuminate red.
Downloaded from www.Manualslib.com
NOTE: Cable Assembly not supplied in box. Ordered direct from
Rentokil Initial to meet specifi c country requirements.
WARNING: You must NOT connect the unit into a lighting circuit.
You must connect the power cable to a standard power socket.
manuals search engine
1. Isolate the electrical supply to the power
socket.
2. Check that the mains voltage displayed
on the unit label is correct for your supply.
3. Check that the cable and plug connector
are not damaged.
Operational Service Mode