Description; Display And Connection Elements - JUMO dTRANS p35 Kurzanleitung

1 Introduction
1.2

Description

NOTE!
Please read this manual before starting up the device. Store this manual in a place that is accessible to
all users at all times.
The pressure sensor serves to measure relative and absolute pressure and monitor it in liquids and gas-
es. The effect of the pressure on the pressure sensor generates a signal, which is amplified, digitalized,
and processed.
The pressure sensor is equipped with an IO-Link interface according to specification 1.1. IO-Link sup-
ports bidirectional communication and is used to exchange process data, parameters, diagnostic infor-
mation, and status messages. The two green LEDs are permanently lit as soon as voltage is supplied to
the device. Once an IO-Link connection is established, the LEDs flash.
The switching behavior and the switching thresholds of the switching outputs (max. 2 pieces; p or n
switching) can be individually configured - along with many other parameters. Any IO-Link master can
be used for the configuration.
The pressure sensor is therefore suitable for use in plant and mechanical engineering in connections to
automation systems. A variety of pressure connections and measuring ranges are available to the user.
1.3

Display and connection elements

(1) Status LEDs
(2) Pressure connection with membrane for recording pressure levels
(3) M12 connection
(4) Protective cap for storage and transport
4
(1) (2)
(1)
(1) (3) (4)
(1)