Adjustable Dead Zone - HORI NSW-228U Bedienungsanleitung

・ If you do not perform step
automatically end.
・ During steps 2∼6, only the steering unit and foot pedal input are enabled.
Button input from the controller to the Nintendo Switch™ will be disabled.
・ Controller settings are stored even if the USB is disconnected.
Gradual (Steady steering)
LED colour Green

■ Adjustable Dead Zone

The Dead Zone is adjustable to seven levels.
Program LED (Left) colour will change to indicate the dead zone value.
Press for 3 seconds
Press
Set Control Toggle
Switch to DP
Press
Press
Press
・ If you do not perform step
automatically end.
・ During steps 2∼6, only the steering unit and foot pedal input are enabled.
Button input from the controller to the Nintendo Switch™ will be disabled.
・ Controller settings are stored even if the USB is disconnected.
LED
after , the Program LED (Right) will turn off after four seconds and button assignment mode will
1 2
Yellow
after , the Program LED (Right) will turn off after four seconds and button assignment mode will
Narrow
1 2
Green Yellow
Default
3 4
Red Purple
Program LED (Right)
will flash (slowly).
Program LED (Right)
will flash (quickly).
Left Program LED colour will
change according to setting
and chart below.
Dead zone value increases by pressing up on the Directional Pad.
Dead zone value decreases by pressing down on the Directional Pad.
Program LED (Left)
will turn off.
(The Program LED (Right) will light green when assigning buttons.)
Default
3 4
Red Purple
Responsive (Easy to turn)
5 6
Blue Light Blue
Wide
Narrow
Program LED (Right)
will turn off.
5 6
Blue Light Blue
7
White
Wide
7
White
7