Assign Mode - HORI NSW-228U Bedienungsanleitung

■ Assign Mode

You can remap the function of buttons using this feature.
Programmable Buttons
ZL / ZR / LSB / RSB / ITEM / L Paddle /
R Paddle / L Pedal / R Pedal
How to Adjust
Directional pad
・ After 4 seconds of inactivity between steps, Program LED (Right) will turn off and program mode will stop.
・ During steps 2, button input from the controller to the Nintendo Switch™ will be disabled.
・ When the Program LED (Left) turns on, it indicates that a button is remapped and will not turn off until button function is reset to default.
・ If you want to disable button function, press and hold for 3 seconds the same button you pressed in step 2 at the time of step 3.
・ If you pressed multiple buttons during step 3, the last button you pressed will be assigned.
・ Controller settings are stored even if the USB is disconnected.
How to reset individual buttons
Use the Step 3 above to individually reset buttons to default.
How to reset all buttons / functions to default
Press for 3 seconds
Press HOME Button
Assignable Functions
A / B / X / Y / L / R / ZL / ZR / LSB / RSB / ITEM / L Paddle / R Paddle
Directional Pad (Right / Down / Left / Up) / Left stick (Right / Down / Left / Up) /
Right stick (Right / Down / Left / Up)
Press for 3 seconds
ASSIGN Button
Press Programmable Buttons
ZL / ZR / LSB / RSB / ITEM
L Paddle / R Paddle / L Pedal / R Pedal
Press Assignable Functions
A / B / X / Y / L / R /
ZL / ZR / LSB / RSB /
ITEM / L Paddle /
R Paddle
or
ASSIGN Button
or
Directional Pad /
Left stick /
Right stick
・ Press the direction
(Right, Down, Left or Up) to
assign the desired function.
or
Left stick
Green LED flashes slowly.
Program LED will turn off and all button
assignments will reset to its default settings.
Green LED flashes slowly.
Green LED flashes quickly.
Green LED turns on.
Right stick
5