Installation - Sartorius YPS02-X serie Installationsanleitung

Installation

6 YPS02-X.. Installation Instructions
Installation
Connecting the Device to AC Power
!Before startup, make sure that the power cable is properly connected to the power
outlet. In particular, the protective conductor must be connected to the housing
of the power supply.
Connect all devices via their equipotential bonding conductor terminals to the
equipotential bonding conductor. Installation must be carried out properly by
trained personnel and according to the standards of the technology.
!The system should only be operated for the first time when it is certain that the
area is not potentially explosive. If deviations are evident during startup due to
transport damage, the system should be disconnected from the power supply and
Service should be contacted (no display, no backlighting despite weight value
display, no reproducibility of the weight value, no stability in the display, etc.)
!Cabling:
– Both cables should be laid fixed
– Flexible cabling with screws available upon request
t Check the supply voltage/frequency and plug design.
Contact your Sartorius dealer if they do not match.
!When operating a balance in an explosive area:
– Follow all current standards and regulations for the installation of devices in the
explosive area.
– Device installation should be carried out by trained personnel and checked
properly.
!Before startup, connect the linked devices to a central equipotential busbar.
h
Only use cables and cable lengths approved by Sartorius,
cables not provided by Sartorius are the responsibility of the operator.