Use Instructions - E.zicom EZIclean turbo silence 400 Benutzerhandbuch

EN

Use Instructions

After the product is assembled :
01. Select and install the plug according to your needs.
02. Pull the power cord out and adjust it to the proper length.
03. Press the power on button to start the vacuum cleaner.
WARNING : Make sure all filter materials are in place
before using the product. The filter material should
not be damaged. The cleaned filter material must be
thoroughly dried before use, otherwise il will cause
damage to the product.
WARNING : Please check the product and power
cord carefully before each use. If the power cord of
the product is damaged, it is forbidden ta use, which
may cause danger. lt is strictly forbidden ta use a
vacuum cleaner ta absorb any stains with water ta
avoid motor burnout and short circuit, resulting in
unnecessary persona! injury and property damage.
ATTENTION : If you see the red mark at the end
of the power cord, press the power cord button
ta retract the power cord ta the red mark invisible
position. Otherwise, the power cord may fall off and
damage the product.
ATTENTION : Please turn off the power immediately
after using the product, otherwise it may cause a fire.
ATTENTION : For surfaces such as curtains that do not require tao much suction, the suction can be adjusted
via the air intake compensa tion button on the hase handle.
04. During the cleaning process, you can switch the suction according to your needs. Press the speed control
button on the left side, the machine switches to the strong working mode, press the speed control button again,
the machine returns to the silent working mode. Two gears can be adjusted.
05. After cleaning is complete, press the power on/off button again to turn off the vacuum cleaner. After turning
off the power of the vacuum cleaner, unplug the power cord and press the power cord button to retract the
power cord.