Battery Safety; Protection And Maintenance - SATA 05201 Bedienungsanleitung

Battery Safety:

Battery explosion or leakage may cause personal injury or fire. In case of exposure to sparks or flames, the
battery fluid may be flammable
Do not splash or immerse into water or other liquids
Do not store or use in places where temperatures may reach or exceed 105 degrees Fahrenheit （45.5 degrees
Celsius）（e.g. outdoor or metal buildings in summer）. To extend the service life, please store the product in a
cool and dry place
Do not burn laser products, even if they are seriously damaged or completely worn. The battery may explode in a
fire and produce the toxic substance when it burns
If the battery contents contact with the skin, wash immediately with mild soap and water. If the battery fluid
enters the eye, rinse eyes in opening with water for 15 minutes or until it is not irritant. If medical care is required,
the battery electrolyte consists of liquid organic carbonate and lithium salt
Opening the battery contents may cause respiratory irritation. Please leave as soon as possible and breathe fresh
air, if the symptoms do not improve, please seek medical attention as soon as possible
If the shell is cracked or damaged, do not attempt to open it for any reason. Do not strike, drop or destroy the
laser product in any way （such as hitting with a nail, striking with a hammer, or trampling）
Do not use any damaged charger or charging line since there may be fire, explosion, leakage or other risk
The longest service life and best performance can be obtained by charging at air temperature between 18° C and
24° C
Termination of Service Life:
1 ） Do not dispose of the product with household waste.
2） Please collect and dispose the electrical and electronic waste in accordance with local regulations.

Protection and Maintenance:

1 ） Do not wet the laser products since the products are not waterproof, and wetting may cause damage to the internal
electronic plate.
2） Do not expose laser products to direct sunlight or heat. The shell and some of internal parts are made of polymer
material and may deform at high temperatures.
3） Do not store laser products in cold environment. Moisture may form on the internal parts during preheating. The
moisture will atomize the laser lens or lead to corrosion of internal electronic plate.
05201
中文
EN DE RU KO PT JA ES
15