M-LOCKS E-Pass EP1750 BM Benutzeranleitung Seite 11

!
Caution!
• The lock has been designed for use in a temperature range from +10˚C to +50˚C and a non-
condensing humidity range from 30% to 80%.
• It may only be cleaned with a moist cloth (do not use aggressive cleaning agents).
• The lock may only be installed by qualified fitters.
• The lock may not be lubricated.
• Never open the lock housing. If it is necessary to disassemble the hardware, only do so in accord-
ance with the technical instructions. If you fail to do so, the lock may no longer function properly
and you will forfeit your right to warranty.
2 SYMBOLS AND SIGNALS
double audible tone, correct
entry
long audible tone, incorrect
entry
3 OPENING THE LOCK
1 2 3 4
Enter the code (Manager Code set at the factory = 1-2-3-4-5-6), if the code is correct a double signal
sounds, turn the knob and open. If the door is not opened within 3 seconds the lock will automatically
lock again.
If the open window expires without entering a valid code the lock is secured again with time delay.
4 LOCKING
Close the door and turn the handle until the stop to the left. The lock is secured.
Check if the lock and the door are closed.
www.m-locks.com
LED flashes
LED illuminated
5 6
E-Pass
V01 EN
1 2
...
digit on keypad
press and hold
5