Master/Slave Mode - Luxibel LX111 Bedienungsanleitung

Menu item Description
P-- Built-in programs
S-- Speed
Snd Sound random program
Sens Sound sensitivity
U-- User custom colours
dim Dimmer speed setting
dim1: Dimmer speed fast
dim2 : Dimmer speed middle
dim3 : Dimmer speed slow
Send data（linking fixture）
Send
send1: Single fixture
send3 : 3 pcs linking
SlA Slave mode（linking fixture）
SLA 1 : Program follows the master fixture
SLＡ 2 : Receive the second program data
SLＡ 3 : Receive the third program data
7.2

Master/Slave Mode

The master/slave mode allows connecting several devices to a single master device. All slave devices will then
work synchronously with the master device.
You need to set one device to master mode and all other devices to slave mode.
1. Connect all devices in series with DMX cables.
2. The first unit in the chain functions as the master device. Set up the unit as described above.
3. On each slave device, press <MENU> until <SLA> is displayed and press <ENTER>.
4. Use <UP> and <DOWN> to select an option and press <ENTER>.
7.3 DMX Mode
This mode allows you to control the device by any universal DMX controller.
 All DMX-controlled devices need a digital start address so that the correct device responds to the signals.
This digital start address is the channel number from which the device starts to ―listen‖ to the DMX
controller. The same starting address can be used for a whole group of devices or an individual address can
be set for every device.
 When all devices have the same address, all the units will ―listen‖ to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you
set individual addresses, each device will ―listen‖ to a separate channel number. Changing the settings of
one channel will only affect the device in question.
To set the device to work with a DMX controller:
1. Press <MENU> to select a channel and press <ENTER>.
2. Use <UP> and <DOWN> to set the DMX starting address (A001-A512) and press <ENTER>.
Example:
To use the 1-channel mode, set the start address of the first unit to 1 (CH1), the second to 2 (CH2), the third
to 3 (CH3), and so on. The highest start address is 512.
Use the table below to define the correct address. The table shows the settings for units 1 to 3. Apply the same
principle for all units and channels.
Channel mode
3 Start address
Channel
5 Start address
Channel
V. 02 – 28/03/2013
LX111
Start addresses
First unit Second unit
1 4 (1 + 3)
1~3
1 6 (1 + 5)
1~5
6
Third unit
7 (4 + 3)
4~6 7~9
11 (6 + 5)
6~10 11~15
Highest start
address
510
508
©Velleman nv