Operation - Luxibel LX111 Bedienungsanleitung

 Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
 Make sure there is no flammable material within a 0.5 m radius of the device.
 Have a qualified electrician carry out the electric connection.
 Connect the device to the mains with the power plug. All devices must be powered directly off a grounded
switched circuit and cannot be run off a rheostat or dimmer circuit, even if the rheostat or dimmer channel
is used solely for 0 % to 100 % switching.
 The device has a power output to supply power to another device. When connecting several devices in a
daisy chain via this output, make sure that the total current does not exceed the power line's nominal
current. Use power cables with an adequate section. If you do not use the power linking feature, be sure to
use the included screw-on cap to prevent any water from getting into the power cords.
 The installation has to be approved by an expert before the device is taken into service.
DMX-512 Connection
 When applicable, connect an XLR cable to the female XLR output of a controller (not incl.) and the other
side to the male XLR input of the device. Multiple devices can be linked through serial linking. The linking
cable should be a dual core, screened cable with XLR input and output connectors.
 Maximum recommended serial data link distance is 500 meters (1640 ft). Maximum recommended number
of devices on a serial data link is 32 devices.
 A DMX terminator is recommended for installations where the DMX cable has to run a long distance or is in
an electrically noisy environment (e.g. discos). The terminator prevents corruption of the digital control
signal by electrical noise. The DMX terminator is simply an XLR plug with a 120 Ω resistor between pins 2
and 3, which is then plugged into the XLR output socket of the last device in the chain.
7.

Operation

The device can be used in the following modes:
 stand-alone mode (with the built-in microphone)
 stand-alone mode
 sound-activated
 stand-alone mode: automatic or sound-activated
 master/slave
 with a DMX512 controller.
7.1 Control Panel Navigation
Access the control panel functions using the four panel buttons located directly underneath the display. From
left to right:
Button Function
<MENU> used to access the menu or to return to a previous menu option
<UP> scrolls through the menu options in ascending order
<DOWN> scrolls through the menu options in descending order
<ENTER> used to select and store the current menu or option within the menu
 The control panel display shows the menu items you select from the menu map. When a menu function is
selected, the display will show immediately the first available option for the selected menu function. To
select a menu item, press <ENTER>.
 Use the <UP> and <DOWN> buttons to navigate the menu map and menu options. Press <ENTER> to
access the menu function currently displayed or to enable a menu option. To return to the previous option
or menu without changing the value, press the <MENU> button.
The menu contains the following items:
Menu item Description
3—CH 3 channel settings
5--CH 5 channel settings
9--CH 9 channel settings
10--CH 10 channel settings
13 --CH 13 channel settings
C-- Static colour show
V. 02 – 28/03/2013
LX111
5 ©Velleman nv