Operation Mode Selection - Hayward Pool ENERGYLINE PRO serie Einbau- & Anleitungshandbuch

4. USER INTERFACE (continued)
Timer 2 settings
After the Timer 1 settings, you will access directly the settings for Timer 2:
and
Proceed in the same manner as for Timer 1.
Nota: To access directly Timer ON2
twice on
Timers suppression (Start and Stop)
1) Press for 2s, Timer ON1
2) Press
to make the time display flash.
3) Press to suppress the Timer
4) Press to validate.
5) Press
for 2s, the Timer
Press once
6) Press
to make the time display flash.
7) Press to suppress the Timer
(*) To access Timers 2
twice . Proceed in the same manner as above.
4.4 Operation mode selection: cooling, heating or automatic
In Mode "OFF" or "ON"
Press the button
If the heat pump is set in heating only or cooling only, changing mode
is not possible.
14
.
.
, the Timer
or
to change mode: cooling, heating or automatic.
, press
flashes.(*)
.
flashes.
flashes.(*)
.
, follow steps 1) or 4) then press
for 2s, then press