User Manual - SBS TWS BT800 Beat Bedienungsanleitung

UK

USER MANUAL

Charging the dock
To charge, it use an USB cable, insert it into the micro USB port and then
connect it to a computer or a portable battery pack.
The LED on the charging dock will flash red when charging and turn to
solid red when the dock has finished charging.
Charging the headphones
Ensure the headphones are fully charged before use --> this takes
around 2 hours. The headphones cannot be used when charging.
1. Position the headphones in the corresponding slots on the charging
dock
2. A solid white LED will switch on when charging is started and will turn
off when charging is complete.
3. The charged headphones will switch on automatically when they are
removed from the charging dock.
Switching on and pairing the headphones as a pair
1.Headphones already placed on the dock
When the headphones are off (removed from the dock), hold down the
button on each headphone simultaneously for 6 seconds, the LED on the
left headphone (main headphone) will flash alternately in white/blue,
whereas the LED on the other headphone will flash blue.
- Activate Bluetooth on your mobile phone --> the headphones are
identified as a single device, search and select SBS BEAT TWIN.
2. Headphones removed from the dock
When the two headphones are removed from the charging dock, after
about 6 seconds, the LED on the left headphone (main headphone)
will flash alternately in white/blue, whereas the LED on the other
headphone will flash blue.
- Activate Bluetooth on your mobile phone --> the headphones are
identified as a single device, search and select SBS BEAT TWIN.
Once the headphones are connected to a smartphone, the LED on both
will flash white once every 7 seconds.
Switching on and pairing a single headphone (left or right)
- Press and hold the button until the LED flashes alternately in white/
blue and you hear "pairing".
- Activate Bluetooth on your mobile phone --> search and select SBS
BEAT TWIN.
Once the headphone is connected to a smartphone, the LED will flash
white once every 7 seconds.
4
Using the headphones
When using the headphones as a pair, the following functions
described can be activated by using just one button on either of the two
headphones. Answering a call: press the button once quickly.
Ending a call: press the button once quickly.
Declining a call: press the button twice quickly.
Play / Pause: press the button once quickly.
Next song: press the button twice quickly.
Digital assistance: hold the button down for 3 seconds on one of the
headphones (function only activated if the feature is already available
on the phone).
Switching off
The headphones switch off automatically when put back in the
corresponding slots on the charging dock.
- Alternatively
- If the headphones are being used as a pair, hold down the button
the main headphone for 6 seconds, you will hear "Power off" and the
blue LED will turn on for 1 second --> both headphones will switch off
automatically.
- If you are using a single heapdhone, hold the button down for 6
seconds.
If the headphones have not been paired to a device within 10 minutes of
being switched on, they will turn off automatically to save power.
Safety precautions
- Read, follow and save these instructions, paying attention to all
warnings.
- Stop using the product immediately if it causes discomfort or pain.
During use it is recommended to keep the volume at a level that is not
harmful to your ears and allows you to hear noises around you. Don't
have the volume up high!
- Store the appliance away from heat, moisture and dust.
- Do not use abrasive detergents to clean the earphones.
- Do not use near water devices (faucets, fountains, swimming pools,
washing machines, etc.) and do not allow the earphones to come into
contact with sharp objects.
- Keep away from WIFI, router or other high frequency transmission
equipment to prevent interruption of signal reception.
- Using the earphones while driving can distract you and increase the
likelihood of accidents.
- Battery life may vary depending on mode of use.
- Use within its range of activity (10m), preferably free from obstacles
along the route of connection to the connected device.
- Keep out of reach of children.
The case must be used only with the earphones included into the
packaging.
5