Safety Instructions; Declaration Of Conformity - Bascom BSM-PWA Gebrauchsanweisung

Carefully follow the operating instructions when connecting this product.
Keep all parts of the product out of the reach of children.
Do not drop the product and do not shake the product. A rough treatment could damage the
internal electronic switch and the fine mechanics.
Do not operate this product near water.
This product should never be placed near or over a radiator or heat register.
Only a qualified technician should service this product. Opening or removing covers may result
in exposure to dangerous voltage points or other risks.
Avoid plugging the device right next to noisy sources such as cell phone chargers, desktop
computers, vacuum cleaners, etc. This can result in poor transmission speed.
Before cleaning the product, remove the product from the power source.
Only clean the exterior of the product, with a soft, dry cloth.
Do not use aggressive chemicals, solvents or strong detergents to clean the product.
Contact your supplier if you have any doubts about connecting the product, the product safety
or the operating mode of the product.
Bascom Camera's B.V. hereby declares that the product is in conformity with the essential
requirements and other relevant provisions of guidelines 2004/108/EC and 2006/95/EC. A copy of
the declaration of conformity can be found on our website: www.bascom-cameras.com/conformity/.

Safety Instructions

Bascom products are designed and tested to meet strict safety requirements.
Carefully read the instructions below before you start working with the
products and, if necessary, consult the instructions again, so you are always
using the product safely.

Declaration Of Conformity

1
English