Operating - LENCO PMX-850 Bedienungsanleitung

OPERATING

Normal function
1. Be sure to switch off the power and to connect to corresponding input sockets.
2. Turn on the power and wait 3-4 seconds till the speaker functions are connected.
3. Select an audio source by pressing the INPUT A key on the front panel to display FM, AUX A,
USB A, BT-A. Press the INPUT B key on the front panel to display LINE B, USB B, BT-B.
4. Turn the SCRATCH/VOLUME/MULTI knob on the front panel or
remote control to adjust the setting of the main volume. Then adjust the volume of INPUT A by A
VOL slider and the volume of INPUT B by B VOL slider.
5. Press the LIGHT button on the remote control to display light mode, then press the SCRATCH/
VOLUME/MULTI knob to change the OFF, R, G, B, RG, RB, GB, RGB, AUTO, DEMO light mode.
6. Press the MUTE key on the panel or remote to mute, press it again to reset.
Press the X Drive on the remote to turn on/off X-Bass effect.
SOUND EFFECT
1. DJ EFFECT
Press SCRATCH, REVB, B.BOX, YEAH, BRING IT, PROC, GEYA, on the front panel, or select SCRATCH,
REVER B, BEAT BOX, YEAH on the remote control, then turns the SCRATCH/DJ EFFECT big knob to
get the corresponding DJ effects.
2. MUSIC EFFECT
Press CLUB, MARVEL, USE, LASER, YEA, on the front panel, then turn the SCRATCH/VOLUME/
MULTI big knob to get the corresponding Music effects.
3. PARTY EFFECT
Press "PARTY EFFECT" on the front panel can select PARTY effect, THRUST, ALARM, VECTOR,
FIREWORK, RAINING.
Push the PARTY booster handle and get the corresponding PARTY EFFECT, when handle reaches
the MAX position, you can get the corresponding special PARTY EFFECT ending
pull the lever to OFF, PARTY EFFECT is turned off.
Light color control function
To control the light modes coming from the speaker panels by "Speaker" menu or "light mode"
button on remote control
• R = red lights flash
• G = green lights flash
• B = blue lights flash
• RG = red and green lights flash
• RB = red and blue lights flash
• GB = green and blue lights flash
• RGB = red, green, and blue lights flash
• Auto = the various color combinations cycle through and flash to the music beat.
• Demo = lights flash and change color as if they were responding to the beat of the music.
Tuner applications
1. Before using the radio functions, you must attach the supplied antenna. Adjust the antenna to
obtain optimum reception.
Press the INPUT A key on the top control panel or the FM key on the remote control, to select
"FM" function.
2. Press the CH+/CH- key on the remote control to change radio channels that you have previously
Saved.
3. Press or hold the TU+/TU- key on the remote control to adjust the radio frequency manually.
4. Press the AUTO key on the remote control,
PMX-850 will scan and store low to high frequency radio channels.
press the VOL+/VOL- key on the
or the "A side" PLAY/PAUSE key on the top panel,
8
sound. When you
the