Maintenance - icklebubba Galaxy Handbuch

General
Remove the car seat from the car before carrying out any
maintenance work.
The seat can be cleaned with soap and lukewarm water. Do
not use any abrasive detergents.
The belt buckle can be cleaned using warm water.
Do not lubricate.
The cover must be washed by hand (maximum 30° C). Do
not use a tumble dryer.
Removing the cover
1. Remove the shoulder harness.
2. Separate the fabric from the car seat shell by gently pulling
on the fabric cover.
Re-fitting the cover
1. To refit the cover, carry out the above instructions in
reverse order.
2. Make sure that the lower section of the cover flaps are over
the upper section.
3. Fasten the shoulder harness adjustment strap under the
shell again.
IMPORTANT!
Never remove the energy absorbing foam.
Never remove the pull strap from the control button.
The fabric can be removed without removal of the pull strap.

MAINTENANCE

18
V.01.20