Monobloc - VALCKE EXTERIORLIVING OCTOO Montageanleitung

2.4.2 Monobloc

1
Place the installation in the final position;
bear in mind that the 6-way valve must
remain accessible .
4
Make sure that the plastic protection (funnel) is placed on top of the filter to prevent
sand/gravel from falling into the mouthpiece of the branch pipe .
6
After filling the filter, remove the residue
of sand at the top of the filter and remove
the funnel .
2
Attach the pump to the pedestal with the
enclosed bolts (+nuts and washers) .
7
The 6-way valve is now placed on the filter and the clamp is fixed around the filter . This
is how the valve is connected to the filter .
3
Place the filter on the pedestal and fill it
with a 1/3rd water .
5
Fill the filter first with gravel (3-5mm) and then
with sand (0 . 4 -0 . 8 mm) .
The sand has an unlimited lifetime and only
need to be topped up in case sand is lost .
Mark the level of sand/gravel to be able to re-
fill the filter to the correct level at a later time .
ENGLISH
53