Carbest 47349 Benutzerhandbuch Seite 33

GB
Using the two cable clamps (7) connect the cables to the reversing light
and follow the following steps for connecting the respective cables�
Place the 12 V + (positive) reversing light cable sideways into the clamp
connector (7) (see image 8)�
Place the red transmitter cable sideways into the clamp connector (7)
(see image 9)�
Using a pair of pliers (not included) push the protruding metal contact
into the cable clamp (7)� This will connect the two cables�
Close the cable clamp (7) fuse cover�
Using the second cable clamp (7) connect the vehicle's 12 V -
(negative) reversing light cable with the black transmitter cable as
shown in images 8 - 11� Then reconnect the negative cable to the
vehicle's battery�
Caution!
If you are unfamiliar with the I installation and the connections or are
unsure with one of these steps, please consult a specialist regarding
the installation! There is a risk of property damage or personal injuries!
Step 8: Installing the transmitter
Remove the protective film from the adhesive strip at the top of the
transmitter and affix in a protected location behind the trunk trim� Also
secure the transmitter with two cable ties (4)� Be sure there are no
electrical loads in the direct vicinity of the transmitter to avoid impairing
the transmission� Now secure the camera and transmitter cables run
in the void of the trunk with cable ties (4)� The cables run may not
interfere with the vehicle's functionality!
Backup Camera System RV 4.3 | 47349
33
Image 8
Image 9
Image 10
Image 11