Instructions For Installation - Teuco 650 Montage- Und Pflegeanleitungen

GB
The product must be installed exactly as supplied by Teuco, otherwise claims under warranty will not be accepted.
must observe the assembly instructions, using only the tools and materials recommended, and the accessories supplied with the pro-
duct.
This manual is an integral part of the product and must be kept for future reference.
Data and specifications indicated are not binding on the company: Teuco Guzzini SpA reserves the right to make such changes as are
deemed appropriate without prior notice and without any obligation to update.
Art. 650
PREPARING THE GROUND
1
- Lay a reinforced concrete foundation, to the dimensions
indicated, on a perfectly level and well compacted surface.
ANCHORING THE BRACKETS
2
- Position the brackets as illustrated, making certain each one is
angled correctly.
3
- Mark the centres for the fixing holes.
4
- Drill the holes for each bracket.
5
- Sink the M16 x 190 threaded rods (grade 304 stainless) to a
minimum depth of 125 mm, securing with masonry plugs and
chemical anchor.
6
- Secure each bracket with the washers and nuts, rechecking the
position.
ERECTING THE ARCH POSTS
7
- Position the posts as illustrated, making certain that those on
the entrance side are correctly placed.
8
- Secure the posts to the brackets with the studs, washers and
nuts.
FITTING THE TOP FRAME
9
- Fix the frame to the arch posts with the bolts, washers and
nuts.
FITTING THE ROOF SECTIONS AND SKYLIGHT
10
- Secure each roof section to the frame and posts with the bolts,
washers and nuts.
11
- Position the skylight on the frame fitted previously, and fix with
washers and nuts.
12
- Fix the cladding strips to the roof sections, making certain to
position the different lengths in the correct sequence.
ANCHORING THE HANDRAIL BRACKETS
13
- Position the brackets as illustrated, making certain each one is
angled correctly.
14
- Mark the centres for the fixing holes.
15
- Drill the holes for each bracket.
16
- Sink the M16 x 190 threaded rods (grade 304 stainless) to a
minimum depth of 125 mm, securing with masonry plugs and
chemical anchor.
20

INSTRUCTIONS FOR INSTALLATION

IMPORTANT
Art. 650 - 651
17
- Secure each bracket with the washers and nuts, rechecking the
position.
FITTING THE HANDRAIL
18
- Pin the central module of the handrail to the brackets using the
bottom studs only - as illustrated - so as to facilitate the next
two steps of the assembly procedure.
19
- Fit the remaining horizontal rails to the uprights of the central
module, bedding the ends in the relative holes with silicone
sealant and being careful to position the different lengths in the
correct sequence.
20
- Locate the free ends of the rails in the corresponding sockets
on the posts, and secure with the screws as indicated.
21
- Secure the central module permanently to the brackets with the
remaining studs, washers and nuts.
Art. 651
ASSEMBLING THE DECK
1
- Layout of deck squares inside the gazebo.
2
- Assemble the deck surround sections inside the perimeter of
the gazebo, by matching one to the next.
3/4
- Place the single deck squares within the surround so as to
make up the pattern as illustrated.
The installer