Werbung
Troubleshooting
If you experience any of the following difficulties while using the system, use this
troubleshooting guide to help you remedy the problem. Should any problem persist consult an
authorized service center.
No power
Check to make sure the power cord is firmly plugged into the power outlet. One of the safety
mechanisms may be operating. In this case, unplug the unit from the power outlet briefly and
then plug it in again so it will reset itself.
No sound
Check that the system is connected securely. If the connection cord is damaged, replace it with
a new one.
Make sure that you connected the system witho audio output to the analogue signal source.
Connect S/PDIF to a digital signal source. Only one type of the connection, depending on your
source, is required.
Make sure, you turned on the signal source device.
Make sure you select the audio output channel on the device. Refer to your device manual if you
are not sure.
Noise sound is heard
Check that the components are connected securely.
The sound loses stereo effect when you play a stereo device
Set the Audio mode to "STEREO" at the stereo device.
Make sure, you connected the system accordingly.
The surround effect is difficult to hear when you are playing a surround sound
sound-track
Check the speaker connections and device settings.
Make sure SRS function is turned on.
The sound comes from one side of the speaker only
Check cable connetions to see if it is securely connected or is damaged. Disconnect and
reconnect cable, or replace any damaged cables.
Difficulty in hearing dialogue
Make sure your input source contains dialogue information.
Program your S/PDIF source device to send 2 ch.
Stereo programs instead of 5.1 ch. RAW/PCM audio program output.
The system does not operate properly
Static electricity etc., may affect the system's operation. Press the POWER button to turn off the
system. Press the POWER button again to turn on the system.
Werbung
