WamBlee W470 Bedienungsanleitung Seite 41

During this stage, your device W470(EX) will transmit in the VHF band
allocated to service international shipping a series of AIS SART ALERT
messages + homing signal 121.5 Mhz.
Manual activation
Should your W470(EX) fail to activate automatically you can proceed with
manual activation. After checking that the knob (1) is in the 'ARMED'
position, press the 'Test/Activation' pushbutton (5). Once pressed your W470
Personal AIS Beacon device will be activated with the same way as it is in
automatic mode.
EN
Deactivation
To deactivate your W470(EX) it is necessary to rotate the knob (1) clockwise,
repositioning it to 'OFF'.
Press the pushbutton (2) inwards to release the safety lock and then,
continuing to hold the pushbutton down, rotate the knob clockwise until the
'OFF' position is reached, then release the pushbutton (2).
The device will be deactivated and stop emitting radio signals.
Periodic checks
Your W470(EX) has been designed and built using the very latest technology
to ensure maximum performance and simplicity of use. As with operation of
the unit, periodic maintenance procedures are designed to be simple and
fast.
One of the most important things that needs checking periodically is the
battery charge.
There are two kinds of tests, a SHORT test that consists in checking battery
state and a LONG test that checks the operation of the GPS module. It is
recommended to carry out a SHORT test once a month, and the LONG test is
recommended on a yearly basis.
The execution of tests over the recommended schedule reduces the life time
of the batteries.
41