Worx WX261 Originalbetriebsanleitung Seite 10

COMPONENT LIST
FORWARD/ REVERSE ROTATION
1.
CONTROL
2. SOFT GRIP HANDLE
3. HOOK
4. BATTERY PACK RELEASE BUTTON
5. BATTERY PACK
ON/OFF SWITCH WITH VARIABLE
6.
SPEED CONTROL
7. VARIABLE 3-SPEED CONTROL BUTTON
8. LED LIGHT
9. 50MM SCREWDRIVER BIT (PH2)*
10. BATTERY CAPACITY INDICATOR
11. COLLET LOCKING SLEEVE
12. BIT CLIP
* Not all the accessories illustrated or
described are included in standard delivery.
TECHNICAL DATA
10
Type designation WX261 WX261.9 (2 -
designation of machinery, representative of
screwdriver)
Rated voltage
No-load speed
Impact rate
Max torque
Chuck capacity
Machine weight
** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
NOISE INFORMATION
A weighted sound pressure L
K = 3dB(A)
pA
A weighted sound power
Cordless Brushless Impact Driver
WX261 WX261.9
20V Max**
0-3000/min
0-3750bpm
230N.m
6.35mm
1.5kg 1.2kg
= 83.6dB(A)
pA
L = 94.6dB(A)
wA
K = 3dB(A)
wA
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum)
determined according to EN 62841:
Vibration emission value:
a = 7 .446m/s Uncertainty K = 1.5m/s²
2
h
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise
emissions during actual use of the power tool
can differ from the declared value depending on the
ways in which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
EN