Carbest 620560 Benutzerhandbuch Seite 15

UK
USE THE FOLLOWING PROCESS TO ADJUST SHUT­OFF
AND BY­PASS PRESSURES
lnstall the pump as the following picture
1. pressure adjustment set
set screw type; 5/64 allen key
2. by­pass adjustment
set screw type; 5/64 allen key
• Remove the pressure adjustment screw completely, mark the screw in relati-
on to the switch housing for reference as to number of »turns«, start screwing
the set screw clockwise »9 to 9½ turns«, as the c  This will increase the
pressure to shut-off at approximately 60 psi
• Remove the by-pass adjustment screw completely, mark the screw in relation
to the by-pass housing for reference as to number of »turns«, start screwing
the set screw clockwise »10½ to 11 turns« as the c  This will increase the
maximum bypass pressure to approximately 67 psi
How to verity the shut­off and by­pass pressures?
• After adjustment the screw, slowly close the valve until shutout The pressure
gauge pointer jitter instantaneous data is shut-off/by-pass pressure
Carbest 4-Kammer Druckpumpe | Diaphragm Pump | 620560
c
15