Technical Specifications - Velleman PEM7D Bedienungsanleitung

maximum 7 m (depends on environmental conditions. Mount the
reflector in that location.
9. When applicable, connect the counter [6] (optional, not incl.) to the
output [5] using the 10 m cable that comes with the counter
(PEM7D/C).
6. Troubleshooting
When problems are encountered, refer to following overview before
contacting your local dealer:
Check that the speaker is set to "CHIME" or "ALARM". "OFF" = silent.
•
Check that the timer and/or volume are not in the "min." position.
•
A red LED indicates proper alignment of the sensor and reflector. If the
•
LED is not lit, realign sensor and reflector. Distance must be at least
50 cm.
Make sure the adapter is firmly connected to the speaker.
•
Make sure the sensor is firmly connected to the input of the speaker.
•

7. Technical Specifications

nominal detection range
light source
speaker
working temperature
power supply
total current consumption
standby current
IP rating
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulting from
(incorrect) use of this device.
For more info concerning this product and the latest version of this
manual, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior
notice.
V. 02 – 27/11/2013
PEM7D
7 m
IR LED
power supply: DC 9-15V
speaker output: chime / off / alarm
(selection by switch)
duration audio signal: about 1 sec. for chime
30 sec. for alarm
timer adjustable: 3 - 30 sec. before alarm
activation
volume adjustable: yes (from 0 to max.)
cable length: ± 9.5 m
-20 °C to +50 °C
DC 9-15V regulated (adapter included)
< 130 mA
25 mA
IP44 / indoor use
5 ©Velleman nv