Installation - Velleman PEM7D Bedienungsanleitung

Familiarise yourself with the functions of the device before actually
•
using it.
All modifications of the device are forbidden for safety reasons. Damage
•
caused by user modifications to the device is not covered by the
warranty.
Only use the device for its intended purpose. Using the device in an
•
unauthorised way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not
•
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
4. Overview
Refer to the illustrations on page 2 of this manual.
Connection diagram
1 input
2 adapter DC 12V
3 speaker
4
selector
5
output
* Not incl.

5. Installation

1.
Mount the included mounting bracket on a sidewall or another suitable
surface at ± 60 cm above the ground.
2. Note: make sure passers-by can not accidentally bump into it.
3.
Attach the sensor [9] to the mounting bracket.
4. [A] Connect the sensor [9] to the speaker [3].
5. [B] Connect the speaker [3] to the mains using the included adapter
[2].
6. [C] Set the selector [4] to CHIME.
7.
[D] Use the included screwdriver to set the timer and volume of the
speaker. Do not force or use any other screwdriver.
8.
[E] Locate the best position for the reflector [8] by moving it against
the wall opposite the sensor until the chime stops and the red
alignment LED on the senor is on. Distance must be at least 50 cm and
V. 02 – 27/11/2013
Keep this device away form rain, moisture, splashing and
dripping liquids.
Keep this device away from dust and extreme temperatures.
Protect this device from shocks and abuse. Avoid brute force
when operating the device.
PEM7D
6 optional* counter PEM7D/C
7 IR beam
8 retro reflector
9
photoelectric beam sensor
4 ©Velleman nv