Operating Environment; Connecting The Power - Edimax ES-3108P Schnellinstallationsanleitung

1. Operating Environment

This switching hub must be installed and operated within the
limits of specified operating temperature (32-131°F) and
humidity (10~95% Non-condensing).
Prevent entering of water and moisture into the unit. If
necessary, use dehumidifier to reduce humidity.
2. Connecting to network devices
The RJ-45 ports on the switch support Auto-MDI/MDI-X
function which allows using straight-through or cross-over
type cables to connect this switch to workstation or hub.
Connect one end of the network cable to the RJ-45 port on
the rear panel, and connect the other end of the network
cable to the RJ-45 port on the network device. Follow the
same procedure to connect all the RJ-45 ports of the switch.
The UTP network cables must comply with EIA/TIA 568
specifications and Category 5 standard for 100Mbps data
transmission. Maximum length: using UTP cable, between
the switch and connected device is 100 meters (300ft).
Once the network cable is connected to both ends and the
attached network device is powered on, the green LNK/ACT
LED should be lit.

3. Connecting the power

Connect the power adapter to the power connector on the
rear panel of the unit; the green Power LED on the front
panel should be lit.
Downloaded from www.Manualslib.com
Do not place objects on top of the unit.
Do not obstruct any vents at the sides of the unit.
Do not position the unit near any heating source such
as heater, radiator, or direct exposure to sun.
manuals search engine
3