Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Verify that your Dual Link 2.5'' Drive Kit includes the following:
• 2.5'' Drive Enclosure
• 6-to-6 pin FireWire Cable
• 2.0 USB Cable
• 4-pin to 6-pin FireWire converter or 4-to-6 pin FireWire Cable
Installing a 2.5'' Hard Drive in your Dual Link Drive Kit enclosure:
Installing on your computer
1. Turn on your computer.
2. Plug the 6 x 6 PIN fi rewire cable or USB Cable into the Computer's
available fi rewire or USB 2.0 port. Then connect the other end to cor-
responding ports or your Dual Link 2.5'' drive kit.
3. At this point, Windows might require you to insert the WINDOWS CD
and copy some drivers automatically.
4. For other versions of WINDOWS 2000 or WINDOWS XP, a drive letter
should appear under MY COMPUTER.
5. For other versions of WINDOWS, please refer to the next section to
fi nish installing Dual Link 2.5'' Drive Kit.
6. If you have a MAC, then you don't need to do anything. The drive will
automatically mount on your desktop.
Downloaded from
www.Manualslib.com
1
Open the drive enclosure
and remove the screw
pack inside.
2
Remove the back plate
and the green conversion
board from the case.
3
With the bottom of the 2.5''
drive facing the smooth side
of the board, align the drive
socket & slide the 2.5'' hard
drive into the pins of the green
conversion board. Make sure
the pins slide all the way back.
manuals search engine
4
Turn board and hard drive upside
down. Screw together with short
screws on each corner.
5
Insert back plate, and drive
into base of enclosure.
6
Place top shell on the enclo-
sure. Carefully turn over.
7
Use remaining 4 long screws to
screw the enclosure together.
page 3
English
Werbung
