Precautions: Read First - US Blaster USB 1380 Bedienungsanleitung

Congratulations on your Purchase
Your new high fidelity bridgeable/stereo amplifier is designed to deliver maximum enjoyment and
one year of trouble free service. Please take a few moments to read this manual thoroughly.
It will explain the features and operation of your unit and help insure trouble free installation.
Features
Four Class ''AB'' High-Current Dual Discrete Drive Stages.
Class ''AB'' Technology MOSFET PWM Power Supply.
Bridgeable & TRI-Mode Operation.
Continuously Variable 12dB/Octave High Pass & 12dB/Octave Low Pass Crossover.
Subwoofer Variable Crossover for Deep Bass Control.
Enhanced Variable Bass Boost +12dB @ 50Hz.
Enhanced Variable Treble Boost +12dB @ 10kHz
Gold Plated RCA & Power, Speaker Terminal.
Soft Start & Muting.
Overload, Thermal, Short Circuit Protection.
Power & Protection indicator.
Remote Level Control (USB 1382)

Precautions: Read First!

If after reading the direction you feel uncomfortable about installing the amplifier in your
car, or not equipped or competent to do so, you should have the amplifier installed by an
authorized installer. It's your car!
Negative battery terminal must be disconnected before any electrical connection are made.
Be sure choose a location that provides substantial ventilation for the amplifier. The most
preferred locations would be in your car's trunk, under the front seats or on the back wall
of a truck.
The location chosen should provide at least "2" of clearance above the amplifier for
adequate ventilation.
If the amplifier is to be mounted vertically be sure that it is in a place where adequate air
will flow along the length of its heatsink fins for cooling.
NEVER mount the amplifier up side down, this will cause the heat to rise back into the
amplifier causing thermal shutdown or possible permanent damage.
NEVER mount the amplifier in a location that is subject to direct sunlight or exposed to
moisture.
Be sure to mount the amplifier to a strong, solid surface which will not give way under the
stress of a sudden stop or accident.
Make sure that the mounting screws will not penetrate the gas tank, brake and fuel lines,
wiring or other critical parts of your car when installe
1