Stand By Mode; Start Up; Projector Power Down; Menu Navigation - 3M 700 series Betriebshandbuch

™
3M Digital Media System 700 Series

Stand By Mode

When the projector is not being used, place it into standby mode.
1. Press the Power button on the Remote Control.
2. The lamp will switch off and the blue LED will illuminate.
Note: The fan motor will continue to run for a few minutes until the projector cools down and then the fan
will turn off.

Start Up

1. Press the Standby button on Remote Control again to illuminate the lamp and project an image on the screen.

Projector Power Down

1. Press the Power button on Remote Control to place the projector in the standby mode (red and blue LED
illuminates).
2. Wait until the cooling fan motor cycles off and the lamp red LED turns off.
Note: Switching the main power off before the fan has cycled off will decrease the life of the projection lamp.
3. Press the Main Power switch on Control Panel to Off.
4. Turn off the power of your input devices.
5. To transport the projector, disconnect all power and connection cables.

Menu Navigation

Most adjustments and settings are available in the main menu and sub-menus. To display and navigate the menu
press the projector Menu Keypad button on the unit or the remote control Menu button. Use the Menu Keypad
arrow buttons or the Direction Knob to move through the menu. Click the Enter button to change a menu item.
Change the menu item by using the Menu Keypad or Direction Pad and then click Enter to return back to menu
navigation.
© 3M 2007. All Rights Reserved.
Basic Operations
19