Set Up/ Installation Instructions For T-Sign; Normal Operation Mode; Installation (Refer To The Enclosed Quick Guide) - AUDIOropa T-Sign Bedienungsanleitung

Set up/ Installation instructions for »T-sign«

Normal operation mode

In order to run »T-sign« in normal operation mode, just start it up by plugging the power
supply in and let it run its startup sequence for approx. five seconds.
During the startup sequence, the »T-sign« indicates which program it runs by the number
of visible of green flashes.
Program one shows one flash and program two shows two flashes (see page 14, program
characteristics).
No signal: »T-sign« panel is dark
Weak signal: Blinking slowly in green
Normal signal: Steady green light
Strong signal: Steady red light

Installation (Refer to the enclosed Quick Guide)

1. Preparations before set-up: A functioning inductive hearing loop, set up in accordance
with the SIS 60118-4 standard and a device providing a sound source to the hearing
loop, e.g. a microphone or a TV.
2. Choose an appropriate position for the »T-sign«. It is not recommended to set up
»T-sign« close to electronic devices due to signal interference.
3. Connect the power supply to the »T-sign« and keep it at or nearby the chosen mount-
ing place.
Make sure that the hearing loop is not in use. Verify that there is no other signal interference
that affects the »T-sign«. The »T-sign« remains dark when there is no detectable signal in
the hearing loop.
Depending on the magnetic field strength of the hearing loop at the chosen location, the
corresponding sensitivity needs to be set on the »T-sign«. A high sensitivity setting in com-
bination with background signal interference might cause the T-sign to show false indica-
tions. If this is the case, consider choosing a different location with stronger field strength
and/or less signal interference from its surroundings.
4. Set two screws into the wall according to the enclosed drilling template (page 17).
5. Fine-tune the sensitivity of »T-sign« with the included screwdriver. Follow the instructions
in the next paragraph "Calibration mode".
12 English