Hanson Electronics D19AL Bedienungsanleitung Seite 4

Introduction
Safety information
Provided with this monitor is a detachable power supply cord with IEC320 style terminations.
It may be suitable for connection to any UL listed personal computer with similar
configuration. Before making the connection ensure that the voltage rating of the computer
convenience outlet is the same as the monitor and that the ampere rating of the computer
convenience outlet is equal to or exceeds the monitor current rating.
For 120Volt applications use only UL listed detachable power cord with NEMA configuration
5-15P type(parallel blades) plug cap.
For 240Volt applications use only UL listed detachable power cord with NEMA configuration
6-15P type(tandem blades) plug cap.
Use only a power source and connection appropriate for the monitor as indicated on the
marking label.
Slots and openings in the cabinet are provided for ventilation;
these openings must not be blocked or covered. Never push objects of any kind into cabinet
slots or other openings.
Never insert anything metallic into the monitor openings.
Doing so may create a danger of electric shock.
To avoid electric shock, never touch the inside of the monitor.
Only a qualified technician should open the monitor s case.
Unplug the monitor from the wall outlet before cleaning. Do not use liquid cleaners or aerosol
cleaners. Use a damp, lint-free cloth for cleaning.
Install the monitor near an outlet that you can reach easily. Disconnect the product by
grasping the plug firmly and pulling in from the outlet.
Never disconnect it by pulling the cord.
6 User's Manual
Power management system
This monitor meets VESA(Video Electronics Standards Association) DPMS(Display Power
Management Signalling)standards. In order for the monitor s power saving feature to function,
the video board or computer must also meet VESA
Power management table
State
Normal
Operation
Sync
Standby
Horizontal Active Inactive
Vertical Active Active
Video Active Blanked
LED Color Green Green/AMBER
Power Less than
110W
Consumption 80% of MAX
Note : The monitor automatically goes through the DPMS steps when it is idle.
To release the monitor from the DPMS condition, press any key on the keyboard.
Connection to your computer
CAUTION
Ensure that both the PC and the display monitor are switched off.
To attach the monitor to your system, as shown in
the following illustrations.
1. Connect the signal cable
2. Insert the AC power cord
3. To turn on the monitor, push the power switch.
Note : To attach the monitor to the Macintosh system, please contact the signal cable
2layer 15pin graphics connector of the system. (
cable is opposite to the IBM compatible system)
Introduction / Installation
®
TM
DPMS standards.
Power saving function mode
Suspend Mode Power-Off Mode
Active Inactive
Inactive Inactive
Blanked Blanked
AMBER AMBER Blinking
Less than Less than
15W 5W
to the 15pin
graphics connector of the system and tighten
the fastening screws.
into monitor and
then into an AC power outlet.
to the
The connecting direction of signal
User's Manual 7