Herunterladen Inhalt Inhalt Diese Seite drucken

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the VDL300MF2! It features a rotating colour mirror disc, creating a fast moving effect. Please
read the manual thoroughly before bringing this device into service. Make sure that the device was not damaged in
transit. If the device is damaged, you should contact your dealer and postpone installation of this device.
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
• This device falls under protection class I. It is therefore essential that the device be earthed. Have a qualified
person carry out the electric connection.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• There may be some smoke or a particular smell when the device is activated for the first time. This is normal and
any smoke or smell will gradually disappear.
• Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
• Note that damage caused by user modifications to the device are not covered by the warranty.
• Keep the device away from children and unauthorised users.
3. General Guidelines
• This device is designed for professional use on stage, in discos, theatres, etc. The VDL300MF2 should only be
used indoors with an alternating current of max. 230VAC / 50Hz.
• Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat (see "Technical Specifications"), dust and
moisture. Respect a minimum distance of 0.5m between the device's light output and any illuminated surface.
• Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
VDL300MF2
VDL300MF2 – MAGIC MOONFLOWER
1
VELLEMAN

Werbung

Inhaltsverzeichnis
loading

Inhaltszusammenfassung für HQ Power MAGIC MOONFLOWER VDL300MF2

  • Seite 1 VDL300MF2 – MAGIC MOONFLOWER 1. Introduction & Features To all residents of the European Union Important environmental information about this product This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment.
  • Seite 2: Installation

    • Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified people. Any damage that may occur will most probably be due to unprofessional use of the device. • Use the original packaging if the device is to be transported. •...
  • Seite 3: Cleaning And Maintenance

    • Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws. • Make sure there is no flammable material within a 50cm radius of the device. • Have a qualified electrician carry out the electric connection. •...
  • Seite 4: Veiligheidsinstructies

    2. Veiligheidsinstructies Wees voorzichtig bij de installatie: raak geen kabels aan die onder stroom staan om dodelijke elektroshocks te vermijden. Raak het toestel niet aan wanneer het in gebruik is: de behuizing wordt warm. Bescherm dit toestel tegen regen en vochtigheid. Verzeker u ervan dat het toestel niet aangesloten is op een stroombron alvorens het te openen.
  • Seite 5: Reiniging En Onderhoud

    1. Draai de schroeven vooraan het toestel los en plaats voorzichtig het bovenste deksel naar achter. 2. Verwijder de oude lamp en breng de nieuwe in. 3. Zet voorzichtig het deksel terug en draai de schroeven vast. Opmerking: Stel het toestel niet in werking wanneer het deksel eraf is. b) Zekering •...
  • Seite 6: Technische Specificaties

    7. Technische specificaties Voeding max. 230VAC/50Hz Verbruik max. 300W Zekering 3A, 250VAC (5 x 20mm) (bestelcode FF3N) Afmetingen 140 x 110 x 250mm Totaal gewicht 2.3kg Lamp 230V / 300W JDC G6.35 (bestelcode LAMP300MR) Max. omgevingstemperatuur 45°C Max. temperatuur behuizing 130°C De informatie in deze handleiding kan te allen tijde worden gewijzigd zonder voorafgaande kennisgeving.
  • Seite 7: Directives Générales

    • Ne regardez pas directement la source lumineuse comme ceci peut entraîner des crises d'épilepsie chez certains gens. • Les dommages occasionnés par des modifications à l'appareil par le client, ne tombent pas sous la garantie. • Gardez votre VDL300MF2 hors de la portée de personnes non qualifiées et de jeunes enfants. 3.
  • Seite 8: Nettoyage Et Entretien

    • Installez l’appareil à un endroit où personne ne peut passer ou s’asseoir et où personne ne peut le toucher. • L’installation de cet appareil exige une solide expérience pratique : le calcul de la charge max. de la construction, les matériaux d’installation requis etc.
  • Seite 9: Instrucciones De Seguridad

    ¡Gracias por haber comprado el VDL300MF2! Está equipado con un espejo giratorio coloreado, que crea un efecto giratorio rápido. Lea cuidadosamente las instrucciones del manual antes de usarlo. Si el aparato ha sufrido algún daño en el transporte no lo instale y póngase en contacto con su distribuidor. 2.
  • Seite 10: Instalación

    4. Instalación a) Lámparas (véase fig.) • Desconecte el aparato de la red antes de instalar o reemplazar una lámpara. • Las lámparas llegan a temperaturas de hasta 700°C. Deje que la lámpara se enfríe antes de reemplazarla. • No toque una lámpara halógena con las manos sin protección. Use un paño para reemplazar una lámpara. •...
  • Seite 11: Limpieza Y Mantenimiento

    6. Limpieza y mantenimiento 1. Apriete bien las tuercas y los tornillos y verifique que no hay señales de oxidación. 2. No modifique la caja, los soportes y las ópticas p.ej. no taladre agujeros adicionales en un soporte o no modifique las conexiones, etc.
  • Seite 12 Trennen Sie das Gerät vom Netz bevor Sie das Gehäuse öffnen. VDL300MF2 VELLEMAN...
  • Seite 13: Allgemeine Richtlinien

    • Bei Schäden, die durch Nichtbeachtung der Bedienungsanleitung verursacht werden, erlischt der Garantieanspruch. Für daraus resultierende Folgeschäden übernimmt der Hersteller keine Haftung. • Lassen Sie dieses Gerät von einem Fachmann installieren und warten. • Das Gerät bei Temperaturschwankungen nicht sofort einschalten. Schützen Sie das Gerät vor Beschädigung, indem Sie es ausgeschaltet lassen bis es akklimatisiert ist (Zimmertemperatur erreicht hat).
  • Seite 14 • Ersetzen Sie die Lampe durch eine Lampe desselben Typs (siehe “Technische Daten”). Befolgen Sie diese Vorgehensweise: 1. Drehen Sie die Schrauben an der Vorderseite des Gerätes los und bewegen Sie vorsichtig den Deckel nach hinten. 2. Entfernen Sie die alte Lampe und bringen Sie eine neue ein. 3.
  • Seite 15: Reinigung Und Wartung

    6. Reinigung und Wartung 1. Verwendete Schrauben müssen fest angespannt werden und dürfen keine Rostspuren zeigen. 2. Das Gehäuse, die Linsen, die Montagebügel und der Montageort (z.B. Decke oder Gebinde) dürfen nicht angepasst werden, z.B. bohren Sie keine zusätzlichen Löcher in Montagebügeln, verändern Sie die Anschlüsse nicht, usw. 3.

Inhaltsverzeichnis