Vitek VT-3548 SR Betriebsanweisung Seite 6

ENGLISH
Foreign Time display & setting
- Press and hold UP key for  seconds. The icon
" " appears on the display.
- Press and hold MODE key for  seconds in
Foreign Time &Temperature display. The
Foreign time can be set as described above by
pressing UP or DOWN key.
- Press MODE key again to confirm and save
the current setting of the foreign time.
- Press and hold UP key for  seconds to
choose between local and foreign time display.
Setting the dual Time
- To enter the dual time setting mode press
MODE key three times until the "DUAL TIME" is
displayed.
- The dual time can be set by pressing MODE
key for  seconds in Dual Time Display. The
hour digits will be flashed for input.
- Press MODE key once. The hour digits of the
dual time display start blinking, you can set
them by pressing UP or DOWN key.
-Press MODE again. The minute digits of dual
time display start blinking, you can set them by
pressing UP or DOWN key.
-Press MODE one more time to confirm the set-
ting.
Light ON/OFF
- Press button [SNOOZE/LIGHT] to switch on
the normal back light for 5 seconds. After 5
548IM.indd 6
seconds it will be switched off automatically.
Projection Light and its adjustment
- Press button [SNOOZE/LIGHT] to switch on
the projection light for 5 seconds. After 5 sec-
onds it will be switched off automatically.
- You can see the current time and temperature
by the two projection image.
- Insert adapter and push down "Continue -
Projection" button. Projection light will be on
continuously until the button is switched off or
the AC adapter is pulled off.
Temperature function
Press °C/°F key to switch between the Celsius
or Fahrenheit temperature display.
Attention! Please utilize the unit and batter-
ies in an ecologically safe manner.
The design and specifications of the appliance
could be changed without a prior notice.
Specifications subject to change without prior
notice.
MINIMUM SERVICE LIFE - 3 YEARS
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim
6
30.03.2007 14:29:33