Time Setting; How To Use The Stopwatch - Vestal ZEPPELIN Handbuch

TIME SETTING

* Before setting the time, check that the chronograph measurement is stopped.
Crown
1. Pull out the crown to the 2. Turn the crown 3. Pull out the crown to the second
clockwise until the click when the second hand is at the
first click.
previous day's date 12 o'clock position.
appears. It will stop on the spot and advance
the hour and minute hands by
turning the crown.
(check that the 24-hour hand is set
correctly)
* When the crown is at the second
click position. Do not press any
button. Otherwise, the
chronograph hands will move.
* Do not set the date between 9:00 P.M. and 1 A.M.
Otherwise the day may not change properly. If it is necessary to set the date during that period,
first change the time to any time outside it, set the date and then reset to the correct time.
Zeppelin Instruction Manuals.ind6-7 6-7
4. Push the crown back in to the
normal position in accordance
with a time signal.
4

HOW TO USE THE STOPWATCH

* The measured time is indicated by the stopwatch hands that move independently
of the center and 24-hour hands.
* The stopwatch can measure up to 60 minutes in seconds.
(Standard measurement)
Ex) 100m race (Press the buttons in following order
START STOP (FINISH)
Stopwatch
minute hand
A
10 seconds
Stopwatch second hand
(A) -------- (A) -------- (B) )
RESET
(Reset to "0'00")
A
B
Button (A) *In stopwatch
function Start/Stop
english
5
5/30/08 4:06:54 PM