urmet Yokis THERMARP Schnellanleitung Zur Installation Seite 17

▶ In the RF WIRELESS menu, use buttons
the rec E5 pairing submenu on the display. Then tap on the "Validate" icon
▶ While the message "rec E5" flashes for 30 seconds, briefly press in the "Connect" hole
on the receiver module with a sharp, properly insulated tool.
▶ The THERMARP thermostat will briefly display the
PASS message if the pairing was successful.
▶ The THERMARP thermostat is now correctly paired
with the receiver and controls the receiver to adjust
the boiler or solenoid valve to 230V according to the
set temperature values.
Important: The THERMARP thermostat may
not be able to communicate with the receiver
if it is out of range. The message Err. 17 will
appear on the display in this case.
See the "How to extend the range" paragraph.
HOW TO EXTEND THE RANGE
All YOKIS wireless receivers also serve as signal repeaters. By adding one or more mod-
ules, you can significantly extend the wireless range by creating a wireless bus between
the various modules on the system.
DS1054-055A
and to navigate the menu and open
Led
Connect
P17
1 press
.