Madeira 10209831 Montageanleitung Seite 46

GB ENGLISH
1 2
Switch off the circuit breaker Remove the six blade holder
of the installation site. screws and mount the blade
holders 8 to the fan unit 2.
WARNING! The distance between the blades and the
wall should be at least 0.6 m.
4 5
At the installation site, fix ade- Install the ceiling bracket with
quate wall anchors (not includ- the screw kit. Make sure the
ed) to the ceiling. ceiling bracket is securely fas-
tened.
WARNING! Wall anchors must fit the ceiling type, the
weight of the fan, and its torque.
7 8
Hang the fan unit 2 into the Connect the cable clip of the
ceiling bracket. Rotate the fan ceiling bracket with the clip of
unit 2 until the rotation latch the fan unit 2.
engages.
10 11
Install the three blades 3 to Check the luminaire covers
the blade holders 8 by use of for secure fit. Fit a lamp (max.
three screws, washers, and 46 W / not included) to the
spring-washers per blade. socket of the fan unit 2.
13 14
Install the two pull chains at Set the rotation direction
the speed and light switch of switch 7 (see chapter "rotation
the fan unit 2. direction").
90
3
Remove the right bracket
screws 9 on both sides. Keep
them for step 9 . Loosen the
left bracket screws 1 mm, but
do not remove them.
6
Connect the cable to the termi-
nal as follows:
L Brown
N Blue
Yellow/Green
9
Install the cover 1 of the fan
unit 2 by attaching it to the
ceiling bracket and reinstall the
screws removed in step 3 .
12
Install the luminaire cover 4 by
tightening the three screws of
the fan unit 2 carefully.
CAUTION! Overtight-
ening might brake the
glass.
14
Switch on the circuit breaker
of the installation site.
1 2
4 5
7 8
1.
2.
10 11
3x
3x
13 14
2x
ENGLISH GB
3
6
2x
9
2x
2x
12
3x
15
91