Operation Of Your Classic Int; Power On - Nagra CLASSIC INT Bedienungsanleitung

OPERATION OF YOUR CLASSIC INT

__________________________________________________________
Proceed only if you have completed the installation steps as
described in the previous chapter INSTALLATION OF YOUR CLASSIC
INT.

Power On

To use your integrated amplifier, you must push the mains switch
to position 1 (ON) first. The mains switch is located on the rear
panel (please see page 31).
The typical Nagra main selector has 4 positions :
This table sums up the different positions vs. actions.
Mains switch
0
I
I
I
I
OFF : similar to STANDBY. The unit is
still powered but the consumption
remains very low.
R : is for Remote Control use.
MUTE : the unit is turned on but the
signal is muted. No sound.
ON : the unit is playing normally.
Main selector
Any
OFF
R
MUTE
ON
35
NAGRA – CLASSIC INT
Action
The unit is switched off
The unit is in standby
The unit can be triggered on
and off remotely
The unit is on and muted (for
warming up for instance)
The unit is playing