Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. ASSEMBLY INSTRUCTION
5.1 Wear full eye and ear protection, substantial
footwear, and long trousers at all times while
operating the product. Do not operate the
product when barefoot or wearing open
sandals. (B1a)
5.2 Swing one leg up. Note: Make sure that the
product is secured so that it does not tip over.
(B1b)
5.3 Insert the wheel shaft. (B1c)
5.4 Swing the other leg up. Make sure that the
wheel shaft goes through the hole in the leg. (B1d)
5.5
a) Insert the flat washer onto the wheel shaft. (B1e)
b) Insert the shaft sleeve onto the wheel shaft.
c) Insert the wheel onto the shaft sleeve.
d) Insert the lock nut onto the wheel shaft.
e) Tighten the nut using the wheel wrench.
f ) Do the same as the other side.
5.6 Turn the product on its legs. (B1f )
5.7 Insert the collection bin. (B1g)
5.8 Pull up the safety switch. Note: The product
only functions only if the safety switch is
engaged. (B1h)
5.9 Connect the product to a power outlet. (B1i)
ATTENTION : Take care when tiling the
unit onto its wheels as the unit has an
uneven weight distribution when tilted and
during wheeled transportation.
6. OPERATION
TO START AND / OR STOP (B2)
1. Press the Forward/Reverse switch (17)
to
position.
2. Press the On/Off switch (18) to ON (I) postion to
start the motor.
3. Press the On/Off switch (18) to OFF (O) postion
to stop the motor.
CAUTION
Damage to the machine due to improper
operation.
Incorrect handling can result in machine damage.
Only feed materials to be shredded after the
machine was switched on. Do not feed materials
to be shredded after the machine was switched
off.
NOTE :
The machine is equipped with a safety switch to
prevent it from being switch on again accidentally
after a power failure.
OVERLOAD PROTECTION (B2)
This machine isequipped with an overload
protection system. To protect the motor
from being damaged, the safety switch will
automatically switch off the power. When the
motor is overloaded.
Wait at least 1 minute before restarting by first
pressing the reset button and then the On/
Off switch. If the motor does not restart, do the
following :
1. Press the safety switch(19).
2. Press the Forward/Reverse Button (17) to
REVERSE
ATTENTION :
Always wear safety gloves when executing the
steps mentioned above.
INSTRUCTION FOR USE
1. Place the material to be shredded in the
opening on the right side. It will the be
automatically drawn into the machine be the
cutter as it turns anticlockwise.
2. Do not stuff the opening completely full to
avoid jamming the machine.
3.Alternate feeding branches and small litter that
is a bit wet and decomposed. This will also help to
avoid jamming the cutter.
4.Squashy kitchen rubbish must be composted,
never put it through the shredder !
5.Branches with leaves must always be entirely
through the shredder and out of the way before
feeding new material into the machine. Make sure
the shredded material is able to fall unobstructed
position.
17
Werbung
Inhaltsverzeichnis
Fehlerbehebung
