Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To switch on the measuring device, press the function button. When switched on, the
device shows:
• air temperature:
• relative humidity
• dew point
• surface temperature
Note: If bars „---", like these „---" show up, they can indicate that the thermistor is not
connected, or is damaged, or that the temperature range is excessive.
Pressing the function key will cause sequential switching between the individual
measured values. The value of the measured parameter is shown enlarged on the
screen; in this way one can highlight the variable of interest. Other parameters are
sequentially shown in this operating mode the bottom of the screen in „the info bar".
Press the function key again to have other values highlighted.
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 |
www.wolff-tools.de
Werbung
Inhaltsverzeichnis
