Safety Advice; Technical Specifications - Tensions SILVER LITHIUM 5.1 Bedienungsanleitung

8.3 Setting the delay
D
The delay (surround delay) compensates the time difference between the incoming
GB
audio signals that can occur when the speakers are positioned at different
distances from each other.
F
E
8.4 Setting the delay on the decoder and on the remote control
Press the "Mode" button several times until Delay, SL (Surround Left) and SR
I
(Surround Right) blinks. Use the upwards/downwards buttons to set the required
value.
You can perform the same setting for the centre speaker. Press the "Mode"
button again until Delay and C (for "Centre" speaker) blinks.
9 Troubleshooting
No sound:
Check the cable connections.
Select the right audio source (analogue/digital)
Quiet sound output:
Check the volume setting.
Correct the balance settings.
Unable to use speakers to full power:
Check the sound of the speakers for noise.
Treble or bass too strong:
Check the Balance settings.

Safety advice

• Do not expose the unit to direct sunlight or extreme heat as this can damage
the components.
• Never open the case yourself. Servicing and repair should only be carried out
by qualified persons.
• Make sure no liquids come into contact with the components as this can result
in damage.
• Make sure no pressure is applied to the loudspeaker mesh as this can damage
it.
• Only use a dry cloth to clean the casing.

Technical specifications

Model no. XS-451
• Satellite loudspeakers: 3" (7.8 cm) magnetically shielded
• Subwoofer: 6.5" (16.5 cm)
• Built-in amplifier
• Frequency response: 40 Hz – 22 kHz
• Power supply: 230V ~
• Signal input: Audio
• Signal outputs: G9, speaker outputs (L, R, SL, SR, C)
• Power supply: AC 230V
• Input decoder/output subwoofer: DC 12V, 0.5A
Analogue: Stereo
Digital: S/PDIF (coaxial/optical)
16