Initial Start-Up And Installation Of Mobile Assistant Programmes - Swisscom mobile XPA V1415 Kurzanleitung

1. Initial start-up and installation of Mobile Assistant
programmes
Insert the SIM card and battery and charge the device
Before you can use your smartphone you will first need to insert the SIM card and bat-
tery and then charge the battery. Remove the battery compartment cover by sliding
downwards and insert the rechargable battery. Turn the smartphone over and slide the
QWERTZ keypad upwards. Open the SIM card compartment by pulling out and releasing
the cover. Insert the SIM card with the gold edge facing downwards. Plug the battery
charger into the sync/charger socket. During charging the LED display is orange. The bat-
tery is fully charged when the LED turns green.
When charging is complete, press and hold down the on/off button (located on the
upper-left of the device) for 2–3 seconds to switch on the smartphone. Wait for
the smartphone to start up. This takes more than a minute. Once the smartphone has
started up a screen will appear for you to enter your PIN number.
For technical reasons the device is delivered in German. This means that device configu-
ration and PIN entry instructions are in German. When you install the Mobile Assistant
programmes you can select your preferred language. You can also change the language
manually at any time via Start > Einstellungen (Settings) > Weitere (More) > Länder-
einstellungen (Regional settings).
Enter your SIM card's PIN number and press "Fertig". The device will now be configured
automatically and then restarted. Once the device has completely restarted the Mobile
Assistant installation programme will launch. Follow the instructions in the next section
if you would like to install the Mobile Assistant straight away.
32
Initial installation of Mobile Assistant programmes
Make sure that the supplied SD memory card is inserted (the expansion slot is located
on the bottom-left of the device). This is required for accessing the preinstalled pro-
grammes. Once device configuration is complete and the device has been restarted the
Mobile Assistant Installation programme will run automatically. Select your preferred
language and then press "Fertig". You will now be guided through the installation
procedure; this will take a maximum of 5 minutes. When installation is complete
the smartphone will again restart. The device is now ready for use.
Note
If you lose the Mobile Assistant memory card or it no longer works during operation,
the software can be downloaded from the Internet at www.swisscom-mobile.ch/
mobile-assistant
33