Siemens SIMATIC NET CP 5603 Betriebsanleitung Seite 34

Operating Instructions (compact) CP 5603
To install and attach the CP 5603 follow the steps outlined below:
1. Shut down your computer and disconnect it from the power supply.
2. Open the computer housing as described in the manual accompanying your Microbox.
3. Set the module address on the CP 5603 as described in Chapter 4.
4. Insert the CP 5603 into the prepared PCI-104 slot. Make sure that the CP 5603 sits firmly
5. Take the 4 supplied distancing bolts M3, 15 mm, 5 mm wrench size and secure the CP
6. Using the screws supplied, screw the Microbox expansion frame for CP 5603 (with
7. Bolt the active RS-485 module to the Microbox expansion frame. Use the supplied
8. Close the computer housing by screwing the cover plate onto the expansion frame.
9. Insert the PROFIBUS cable in the PROFIBUS socket of the active RS-485 module.
10. Reconnect the computer to the power supply and start up the computer again.
34
and uniformly.
5603 using the distancing bolts below it.
components fitted) to the housing of the Microbox PC.
locking bolts 4-40 UNC, 8 mm, 4.5 mm wrench size.
CP 5603 Operation Instructions (compact)
A5E02146341A-01