Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Slide hard drive into SATA connector and tighten
the screws
3
Push the drive caddy back into the enclosure.
4
Connect the LED signal cable to the PCBA.
5
Make sure to fasten the 2 screws on the back of
the enclosure.
6
Connect the USB 3.0 cable to the PC, the HDD will be recognize.
If you need to replace the hard disk, close all windows, remove devices safely and the
HDD to stop running. Then follow the instructions from step 1. to 6. to remove and replace
the HDD.
Note
1.
When connecting the enclosure for the first time, please wait until it is recognized
(different OS and different hardware may cause delay).
2.
The enclosure is also compliant to USB 2.0 interface, reaching a transfer rate of maxi-
mum 480Mbps.
3.
If the desktop or laptop does not support USB 3.0 interface, please use the external
PCI Express card (for desktop), or PCMCIA Express card (for laptop) to upgrade the
system to the best USB 3.0 transfer rate available.
4.
Please ensure that the USB 3.0 host card driver supports the operating system.
5.
Before connecting to the PC, please ensure that the HDD is installed correctly.
6.
Please partition and format the new HDD before use.
7.
To avoid any loss of data, do not remove the enclosure while the HDD is in use.
8.
Under Windows XP OS, the maximum capacity of the HDD is 2TB (Please check
Windows official website for detailed information).
9.
If the HDD is not in use, please leave it disconnected.
10.
This product is for use in dry, indoor locations only. Avoid exposure to wet or moist
conditions, only take hold of it with dry hands.
7
Werbung
